Pressure sensor PT2 - M12

Product information "Pressure sensor PT2 - M12"

This sensor was developed for economical pressure measurements. Beside the usual sensor applications, for example feedback for control systems or continuous surveilance, this sensor can also replace pressure switches due to the low costs. The sensor can be used to surveil a multitude of mediums due to the high quality of materials that have been used. Up to 80°C the sensor is temperature compensated to increase the quality of the results.

Other options are available as special orders, different output signals with lower voltages for single board computers and different pressures. You can find this sensor with other electrical connectors under the tab similar products.
This pressure sensor is by default equipped with an M12 plug.

Electrical connection:	M12 - 4-pole

Accesories

Sensor LED Display with switch functionalities NOM13

This display is intended to add a direct read-out as well as pressure switch functionality to sensors.The display is simply plugged into the sensor, please note that the 43650A connection on the output side has a different layout to accomodate the two switches.As an LED display, it can be easily read in dark conditions.Configuration is done with the two buttons at the front, which can easily be done, even in the field.The two npn exits have a maximal output of 100 mA. These can be freely configured as NO, NC, set point and hysteresis.Due to the low voltage loss, the normal power supply of the sensor can simply be used. An additional power supply is therefore not necessary.Again please note that the DIN43650A output layout is different from the usual layout, check the data sheet for details.The display has to be configured by the customer.

From €44.91*

Details

PUR cable for pressure sensors with M12 4-pole a-coded connector 5m

This cable is intended for our pressure sensor with M12 connectors. It features a 4-pole a-coded connector.The connector is available in a straight and an angled version.The cables are 5m long and have four wires with 0.34mm².The plastic mantle is made of PUR and therefore very durable. Pin layout:1: brown2: white3: blue4: black

€20.60*

Details

Reduction G 1/2 to G 1/4 with aluminium washer

Reducing nipple with aluminium seal outer thread 1/2 inner thread 1/4 for pressure sensors PT2

This reducer can be used if the PT2 sensors are to be fitted to a G 1/2" connection instead of a G 1/4" connection.Materials: Brass (reducer), aluminium (sealing washer)Temperature range: -40 ~ 150 °CPermissible pressure: 60 bar (reducer), 18 bar (sealing disc)

€12.70*

Details