Pressure sensor with display NOM13
€152.44*
Available, delivery time: heavily dependent on the destination
with DIN 43650A connection (18 mm). Another designation is connector following DIN EN 175301-803
This sensor was developed for economic pressure measurements. Beside the usual tanks of sensors, like feedback for regulating systems or for on-going surveillance, this sensor can, with the packaged display, also replace pressure switches. Due to the resistant materials, this sensor can be used with a multitude of media. Up to 80°C, this sensor is temperature compensated to increase accuracy.
The sensors are available with 0.5% accuracy (f.s.) from stock.
This set contains the sensor and the display NOM13, enabling the sensor to replace both manometers, pressure switches or other sensors with display.
This combination offers two outputs for simulated switches for the user. Therefore the plug layout is changed to accomodate the two additional ports.
Note: Display is not pre-configured.
Package contains sensor PT2, display NOM13, plug with gasket and long screw
Attention: The display increases the necessary minimum supply voltage of the system:
Necessary supply voltage for sensors with 4-20 mA output: 16 - 30 V
| Electrical connection: | DIN 43650A |
|---|
Accesories
