Sensor LCD Display NOM11
€30.38*
Available, delivery time: heavily dependent on the destination
This plug-In display is intended for integration into existing sensor connections.
This display is compatible, depending on the variant, with all sensors, which have a 0 - 10 V or a 4 - 20 mA signal.
Connecting the display is very simple as the original signal is passed through. Simply open the existing DIN 43650A connection, insert the display and close the connection again with the included longer screw.
If the display has not already been configured, you can configure it now.
Because the display causes a voltage drop of less than 3.5V, in most cases the supply voltage of the sensor does not need to be raised. An additional power source is not needed.
Once the display is configured, it can be used as a quick monitoring tool in case of problems. Within a minute the display is installed, the measured value of the sensor is displayed and the source of the problem can be narrowed down.
This way you can save valuable time solving the problem.
Due to the low cost of the display it is economical to outfit an existing sensor with it than to have a manometer at a different connection.
The display is equipped with background lighting, offering tireless read
The illumination of the display enables fatigue-free reading even in dark surroundings.
Included: Display, with DIN 43650A connection: long screw as well as gasket as seen on the pictures
Connection layout: DIN 43650A: 4 - 20 mA: 1: + 2: - 3: empty; 0 - 10 V: 1: + 2: - 3: signal
The display has to be configured by the customer.
| Electrical connection: | DIN 43650A |
|---|
Accesories
